A True Lightweight Cementitious Coated Crown Moulding System
This is not your father's crown moulding...
-
Cementitious Polymer Fortified Lightweight Coating is engineered to maintain stability, preventing expansion or contraction that could cause joints and seams to separate. Unlike wood, it does not shrink after installation, ensuring a durable and seamless finish.
-
Our product weighs less than one pound per linear foot, offering ease of handling and installation. It can be installed using a standard drywall joint compound, simplifying the installation process further.
-
Pre-mitered One Piece Corners - including inside corners, outside corners, and end caps
with standard 45° and 90° angles, eliminating any special angle cuts and connections. -
Tru-Align System™ - for fast and precise alignment of pre-mitered corners and mouldings for professional installation results every time.
-
Cemetrim Easy Grip™ - a cutting guide for making precision straight cuts with the use of a basic handsaw.
-
Our product is designed for DIY installation and can be installed by most individuals without the need for special skill sets.
-
Our product installs seamlessly without the need for power tools, hammers, nails, drills, screws, stud finders, glue, clamps, wood putty, caulking guns, caulking, angle finders, 4ft levels, miter-boxes, air compressors, or nail guns.
-
Our product installs in mere hours, rather than days, using a standard drywall joint compound readily available at any home improvement center or hardware store.
-
Before proceeding with installation, we strongly recommend reviewing local building codes to ensure compliance and adherence to regulatory standards.
Introducing an affordable decorative crown moulding that seamlessly complements your walls and ceiling.
A complete moulding SYSTEM, designed and engineered
specifically for any drywall or plaster wall;
STEP 1 - INSTALL CORNERS
Step 1 - Install the pre-mitered corners according to the provided instructions.
Apply spackle to corner
Insert Tru-Align cleat into
Tru-Align grove as shown
Adhere pre-mitered corners to wall and ceiling
Step 2 - Install the mouldings according to the provided instructions.
Apply joint compound to the rear of the moulding for installation.
Align the moulding to the Tru-Align cleat and firmly adhere it to the wall and ceiling. It's that simple!
Measure the final length of moulding required for the wall.
-
Begin by placing the moulding on a flat surface.
-
Position the Cemetrim Easy Grip™ cutting guide on the desired shape.
-
Proceed to cut along the guide using a standard handsaw, as illustrated.